Knowledgebase
IPv6 authentication
Posted by Pundreek Kumar on 15 October 2014 01:53 PM

After done ipv6 setting on the MSC, if found that User behind MSC with ipv6 is able to login but not able to browse. On further diagnose we found that the issue in communication between MSC and its ipv6 gateway. To rectify this issue we need to do below steps:

1- Connect a PC configured with IPv4 and IPv6 same as MSC on the same port on which MSC is connected (PC2 place as shown in attached diagram.)
2- Check the IPv6 connectivity on your PC.
3- If step 3 passed then connect MSC in place of PC and do further diagnose.
4- If connectivity gets through post diagnose the issue at 4th step then test user browsing post authentication via ipv6.

 

(1 vote(s))
Helpful
Not helpful

Comments (0)